Related posts

STM32 AD5621 DAC Sinus Wave Generation

STM32 APDS-9005 Luminance Sensor Interface

STM32 12-bit DAC MCP4921: Analog Signal Generation

10 comments

giáp July 27, 2024 - 8:32 am
very good! thanks so much
Marwen Maghrebi July 28, 2024 - 9:32 am
Thank you! I'm glad you found it helpful! 😊
Unarine July 30, 2024 - 2:51 pm
how much baude rate did you put in Virtual terminal
Marwen Maghrebi July 30, 2024 - 3:17 pm
I used a baud rate of 115200 in the virtual terminal
Inas November 9, 2024 - 9:17 pm
Very good, but in Proteus 8, when I click run, I get this message: "No power supply specified for net VDDA in Power Rail Configuration. No power supply specified for net VSSA in Power Rail Configuration."
Marwen Maghrebi November 10, 2024 - 9:29 am
1-First, navigate to the power rail configuration: -Click on "Design" in the top menu -Select "Configure Power Rails..." 2-For VDDA configuration: -In the Power Rail Configuration window, select "VCC/VDD" from the Name dropdown -Set Voltage to 3.3V -Make sure Class is set to "POWER" -Use the "Add->" button to connect VDDA to VDD You should see both VDD and VDDA listed in the "Nets connected to VCC/VDD" box 3-For VSSA configuration: -Switch to "GND" in the Name dropdown -Voltage should be 0V -Class should remain as "POWER" -Use the "Add->" button to connect VSSA to GND You should see GND, VSS, and VSSA listed in the "Nets connected to GND" box Make sure "Use default power rail connections?" is checked at the bottom of the window Click "OK" to apply the changes After completing these steps, the error messages about VDDA and VSSA should be resolved, and your simulation should run properly. The power rails are now properly configured with VDDA connected to the 3.3V supply and VSSA connected to ground.
Inas November 9, 2024 - 11:04 pm
Bro, Can you add me on teams to talk about project,i need this project for school,but can not run it,
Marwen Maghrebi November 10, 2024 - 9:33 am
I don't have Teams right now, but you can contact me via email if you want : " marwen.maghrebi@theembeddedthings.com " . Let me know what specific issues you're having with the project, and I'll try my best to help you resolve them.
Inas November 11, 2024 - 9:58 pm
Marwen, could you check the email I sent you if you have time?
Marwen Maghrebi November 15, 2024 - 8:39 pm
Inas, I apologize for the late reply. I haven't received any email from you. Could you please try contacting me at theembeddedthings@gmail.com ? Thanks!
Add Comment